The first thing to do with your Rhine Spa is to set the time.
In order to do this, hold down the M button for 5 seconds until rtC flashes on the screen
Use the button to change the minutes
Use the button to change the hours
Once you’ve selected the correct time wait for 4 seconds and it will go back to the main screen.
Press and hold M for 5 seconds until rtC flashes on the screen. Press again for FSt - this is Filtration Start
Time. During filtration the system is cleansing itself, purifying the pipeline equipment and heating the water.
This should ideally bet set to a time when you are asleep and therefore not going to be using the tub. We
recommend about 4am.
Use the button to cycle between times
Once you have set a time press M again until FTl appears. This is the duration of the filtration cycle. We
recommend 2 hours. Use the arrows to select a time.
If you press M again and see Adj, please ignore this. This is to fine tune the temperature sensors in the spa
and is only to be used by a Danz Spas technician.
To Next Page
Loading...