Darfon B259-201 - User Manual

User’s Manual
Model Name
B259-201
Input Voltage
AC100-240V 50/60Hz
Output Voltage
DC18-42V 5.6A(168W Max.)
Charging mode
Constant Power
State
Red LED
Green LED
Orange LED
Battery unconnected
Initial pre-charge
Battery Capacity < 20%
Battery Capacity 20~39%
Battery Capacity 40~59%
Battery Capacity 60~79%
Battery Capacity >= 80%
Charge completed
Battery failure / Charger failure
LED is flashing
Operating
-10 to 40 ℃
5 to 95 %RH
Non- Operating
-20 to 65 ℃
5 to 95 %RH
When getting through AC power, please check the power LED
lighted “Green” first(not plug-in Battery yet), If power LED not
lighted “Green”:
Please confirm the AC power cord is well connected or not.
After check AC power cord is well, and LED still not lighted
“Green”, please send back to repair.
When getting through AC power, and the power LED lighted
“Green”, then plug-in Battery, if power LED is Blinking Orange or
Green, please check:
If the output plug is well connected or is it with reverse polarity?
Please confirm the connection of the connector
If the battery is out of use? Please replace of the new battery.
If the charger broken?
Please send back to repair.
Please remove AC power and plug-in again if LED lighted Orange
blinking. However, if the LED Orange blinking symptom was still
occurred after doing charger reset, please return to the supplier.
Please avoid to plug in & out quickly in turns.
Battery Charger
SPECIFICATION
CHARGING LED INDICATION
TROUBLESHOOTING
CHARGER OPERATING TEMPERATURE/HUMIDITY RANG

Darfon B259-201 Specifications