Daspi PASSAGE - Technical Reference and Troubleshooting; Technical Parameters; Troubleshooting Guide

PASSAGE
- Lubricate the bearings, supports and hinges. The engine does not
need any other lubrication.
TECHNICAL PARAMETERS
Voltage: 230v 50Hz
Motor: DC 24V
Frequency: 433-868 MHz
Maximum speed: 100 mm/s
Rolling Code
Max. use intensity: 4 minutes
Use only in dry environments
Force in stand-by: <5W
TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
The door does not
respond, the LED is off
Disconnection of the
light motor
Check if the motor is
correctly connected
While the door is
opening or closing, it
stops in full maneuver
and changes its
meaning. The LED
flashes quickly
The opening / closing
force is higher than
the system
1. Check the door
balancing system
2. Look at the setting
of the reversing force
The door does not
lower and can not be
closed
1. The contact of the
photocell is opened by
the presence of an
obstacle
2. The photocell is
activated, but not
connected
1. Remove the
obstacle
2. Disable the
photocell or connect it
The door does not
open or close
completely
The programming is
not correct
Redo the travel
schedule
The wall button works
but the remote
control does not work
1. The remote is not
recorded
2. The remote has no
battery
Save the command
following the
instructions
The range of control
has been reduced, the
The control battery is
running out
Replace the control
battery