2
Displays the Set
Points screen.
Displays the system
Information Screen.
1. Home Screen
There are several touch sensitive icons on the home screen. Listed below is how each one works when it is touched.
2. Home Screen Status Icons:
Icons will appear when a specific operation is running as described below:
Fan On – If fan is EC fan type, speed modulation percentage is also shown.
Compressor On - A number next to the icon appear indicates cooling stages. If compressor is
variable speed type, speed modulation percentage is also shown.
Humidifier On - If modulating type, humidity demand modulation is also shown.
Dehumidification On
Heaters On - A number next to the icon indicates how many stages are on. If SCR reheat type,
heat modulation percentage is also shown.
Chilled Water Cooling On – If unit has a modulating valve, valve modulation percentage is also
shown.
Energy Saver Available – Shown when optional energy saver chilled water is available to
provide cooling.
CO2 Valve On – (gPOD model that has CO2 control enabled only).
Go to monochrome display emulation mode
to access set-up menus.
Displays the next screen.
Displays the Alarm Log screen.
Turns the unit on or off.
Red = unit is off, Green = unit is on.
Pop-up Active
Alarm message
screen.
LED Unit Status
White = Fan On
Blue = Cooling
Green = E-Saver
Red = Alarm
To Next Page
Loading...