Data Aire gForce Ultra - VFD Parameter Settings

gForce Ultra IOM
76
• When done, press the Auto on key to return to normal operation controlled by the dap4
controller.
NOTE: If more information is required, see the full operating manual for the
Danfoss VFD drive system.
VFD Parameter Settings
The VFD parameters can be setup from the Local Control Panel (LCP) on the face of the VFD.
Figure 1 Local Control Panel
WARNING: When changing parameters, the VFD must be powered off
then on (i.e., cycle the input AC power) before the new parameters will
take effect.