DataComm Electronics 45-0061-WH

To Next Page

Installation Diagram – Front View

Installation Diagram – Back View

WARNING

 DataComm Electronics’ products shall be installed and used only as indicated in DataComm Electronics’ product instruction sheets.

 Instruction sheets are available online at www.datacommelectronics.com.

CAUTION

 For shock protection, this device must be properly grounded.

 Use copper wire only with this device.

IMPORTANT INSTRUCTIONS

 Read and understand all instructions.

 Follow all warnings and instructions marked on the product.

 Do not use this product near water, for example near a bath tub, wash bowl, kitchen sink, laundry tub, in a wet basement, or near a

swimming pool.

 SAVE THESE INSTRUCTIONS.

Instruction / Installation Sheet

Expandable Media Box

with Duplex Surge Suppressor

Part # 45-0061-WH

DataComm Electronics, Inc.

6349 Peachtree Street

Norcross, GA 30071-1725

888.223.7977

770.662.8205

www.DataCommElectronics.com

Parts Included:

• Expandable Media Box with Expandable Cavity

• Old Work Electrical Box with four (4) Mounting Screws

•

15 Amp/125 Volt Duplex Surge Suppressor

• Flexible Pass-Through Accessory Plate

• Six (6) Port Keystone Accesory Plate

• Blank Accessory Plate

Tools Required:

• Drill with Phillips Bit or Phillips Head Screw Driver

• Pen or Pencil

• Sheetrock Saw or Utility Knife

•

ft. Tape Measure

Use the Expandable Media Box with Duplex Surge Suppressor to install low voltage cables behind your

HDTV or other display device. The Media Box can be installed with the receptacle on the left or right side

(see Installation Diagram below).

Features of the Expandable Media Box with Duplex Surge Suppressor include:

•

Compact size fits behind small and large TVs

• Expandable Cavity adds accessible storage space inside of the wall

• HDTV/display device plug recesses completely into the wall when plugged into the Media Box

• Flexible Pass-Through Accessory Plate conceals low voltage pass-through opening

Page 1 of 2

05/01/2014

Concealed Wiring

Hidden

Storage

Cavity

(hidden in wall)

Flat Screen TV

Concealed Wiring

(hidden in wall)

Hidden

Storage

Cavity

Need help?

Do you have a question about the DataComm Electronics 45-0061-WH and is the answer not in the manual?

Summary

Installation Instructions

Figure 1: Top View

Shows needed space between the drywall and the studs for installation.

Figure 2: Cutout Reference

Refer to the included template to make your cutout.

Figure 3: Power Source Connection

Run the source of power to the included Old Work Electrical Box.

Figure 4: Surge Suppressor Wiring

Connect the Duplex Surge Suppressor to the building wire.

Figure 5: Securing the Electrical Box

Use provided screws to secure the Old Work Electrical Box to mounting studs.

Figure 6: Installing the Media Box

Insert Media Box into opening, pull cables, secure with wings, and push cavity.

Figure 7: Final Check

Media Box is installed and ready for TV mount.

Summary

Installation Instructions

Figure 1: Top View

Shows needed space between the drywall and the studs for installation.

Figure 2: Cutout Reference

Refer to the included template to make your cutout.

Figure 3: Power Source Connection

Run the source of power to the included Old Work Electrical Box.

Figure 4: Surge Suppressor Wiring

Connect the Duplex Surge Suppressor to the building wire.

Figure 5: Securing the Electrical Box

Use provided screws to secure the Old Work Electrical Box to mounting studs.

Figure 6: Installing the Media Box

Insert Media Box into opening, pull cables, secure with wings, and push cavity.

Figure 7: Final Check

Media Box is installed and ready for TV mount.

This document describes the DataComm Electronics Expandable Media Box with Duplex Surge Suppressor, Part # 45-0061-WH, an instruction and installation sheet for a device designed to manage cables and power behind HDTVs and other display devices.

Function Description

The Expandable Media Box with Duplex Surge Suppressor is designed to facilitate the installation of low voltage cables and provide power behind HDTVs or other display devices. It allows for the complete recessing of HDTV/display device plugs into the wall when plugged into the Media Box, ensuring a clean and flush installation. The device can be installed with the electrical receptacle on either the left or right side, offering flexibility in placement. A key feature is its "Expandable Cavity," which provides accessible storage space inside the wall for excess cables or small devices, helping to keep the installation tidy and organized. The integrated duplex surge suppressor protects connected electronics from power surges.

Important Technical Specifications

The product includes several components:

Expandable Media Box with Expandable Cavity: The main housing unit that provides the structure and storage.
Old Work Electrical Box: A standard electrical box for in-wall installation, complete with four mounting screws.
15 Amp/125 Volt Duplex Surge Suppressor: An electrical outlet with two receptacles, designed to protect connected devices from power surges. This component is rated for 15 Amperes and 125 Volts.
Flexible Pass-Through Accessory Plate: A plate designed to conceal the opening through which low voltage cables pass, while allowing flexibility for cable movement.
Six (6) Port Keystone Accessory Plate: A plate that can accommodate up to six keystone jacks (e.g., for Ethernet, HDMI, coaxial cables), providing a modular solution for various low voltage connections.
Blank Accessory Plate: A cover plate for unused openings, maintaining a clean aesthetic.

Tools Required for Installation:

Drill with Phillips Bit or Phillips Head Screw Driver
Pen or Pencil
Sheetrock Saw or Utility Knife
6 ft. Tape Measure

The device is designed for use with copper wire only and requires proper grounding for shock protection. The electrical wiring should adhere to all local electrical codes. The surge suppressor connects to a 14/2 with ground UL approved electrical building wire from a power source.

Usage Features

The Expandable Media Box offers several usage benefits:

Compact Size: Designed to fit behind both small and large TVs, making it versatile for various display sizes.
Expandable Cavity: Provides additional storage space within the wall, ideal for concealing excess cables, small media players, or power bricks, contributing to a clutter-free environment.
Flush Installation: Allows HDTV/display device plugs to recess completely into the wall, eliminating unsightly gaps and creating a sleek, professional look.
Flexible Cable Management: The Flexible Pass-Through Accessory Plate helps manage low voltage cables, while the Six (6) Port Keystone Accessory Plate offers modularity for different cable types (e.g., HDMI, Ethernet, Coaxial).
Surge Protection: The integrated 15 Amp/125 Volt Duplex Surge Suppressor protects valuable electronics from power fluctuations and surges.
Installation Flexibility: The Media Box can be installed with the receptacle on either the left or right side, adapting to specific installation requirements and preferences.
Easy Integration: Designed to be installed before the TV mount, allowing the TV mount bracket to be installed per the manufacturer's instructions after the Media Box is in place.

Maintenance Features

While the document does not explicitly detail maintenance features, it provides crucial instructions for safe and correct installation, which indirectly contribute to the longevity and proper functioning of the device:

Proper Grounding: Emphasizes that the device must be properly grounded for shock protection, which is a critical safety and operational requirement.
Copper Wire Only: Specifies the use of copper wire only, ensuring compatibility and preventing potential electrical issues that could arise from using incorrect wire types.
Adherence to Electrical Codes: Instructs users to follow all local electrical codes when running power to the Old Work Electrical Box, ensuring a safe and compliant electrical installation.
Wiring Instructions: Provides detailed instructions for connecting the hot line (black), neutral (white), and grounding (green or bare) wires to the surge suppressor, ensuring correct electrical connections.
Secure Mounting: Instructions for securing the Old Work Electrical Box and Receptacle to the mounting studs, and for fastening the Media Box to the drywall with screws and wings, ensure a stable and durable installation.

Important Safety Instructions (to be followed for proper maintenance and operation):

Read and understand all instructions.
Follow all warnings and instructions marked on the product.
Do not use this product near water (e.g., bath tub, wash bowl, kitchen sink, laundry tub, wet basement, swimming pool).
SAVE THESE INSTRUCTIONS for future reference.

By following these installation and safety guidelines, users can ensure the device operates safely and effectively, minimizing the need for extensive maintenance. The robust design and proper installation contribute to its long-term reliability.