How to test and mark layout
User Manual 105
How to test and mark layout
In “STANDBY SHUTTER CLOSED” state, press Limits All button in the Laser Tool-
bar to
adjust the object position in the marking field:
Limits function: displays the
bounding box of the object(s)
present in the document. Margins
are displayed using a red laser
pointer
W
ARNING
Marking highly reflective materials might cause optical feedback into laser marker.
This may result into irreversible damage of the optical components of laser marker.
Verify that the position and geometry of the object to mark does not cause any reflec-
tion into the optical aperture of the la
ser marker F-Theta scan lens.
Please contact our Customer Support Service for
support on your particular applica-
tion.
Optical induced damage caused to laser marker by
back reflection from high reflective
materials is not covered by warranty.
To Next Page
Loading...