How to use Command Box signals to mark layout
User Manual 107
How to use Command Box signals to mark layout
Automate the marking process allowing documents to be marked using external
START_MARKING
and
STOP_MARKING
signals, which can be generated by PLC or
other external devices.
Click on the Save
to Device button to save the layout in the device memory:
Click on the Show Laser Engine button to display Laser Engine window:
Documents tab: lists all the
project or documents that have
been saved to the system
Laser marker State
Document preview: this area
shows how the graphic objects
will be actually marked
AUTO/MANUAL Mode button allows switching between the two available working
modes:
• Auto mode: the engraving operations are executed automatically using
ext
ernal signals.
• Manual mode: used for displaying the margins of the graphic objects to be
m
arked and to test layouts.
To Next Page
Loading...