On moisture condensation
User Manual 5
On moisture condensation
If the laser marker is brought directly from a cold to a warm location, moisture
may condense inside or outside the laser product. This moisture condensation
may cause a malfunction of the laser marker.
Note on moisture condensation
Moisture may condense when you bring the laser marker from a cold place into a
warm place (or vice versa) and when you use the laser marker in a humid place.
If moisture condensation occurs
Turn off the laser marker and wait about 1 hour for the moisture to evaporate.
How to avoid moisture condensation
Before moving the laser marker from a cold place into a warm place, put it in a
plastic bag and seal it tightly. Remove the bag when the air temperature inside
the plastic bag has reached the ambient temperature (after about 1 hour).
To Next Page
Loading...