Installation environment
User Manual 15
Installation environment
Control rack
The control rack must be installed in a suitable environment in order to allow
proper air flow and correct housing of the cables.
The control rack uses a forced air cooling system: an adequate air flow is neces-
sary to guarantee its correct cooling. Install the control rack so that air flow is
no
t obstructed. Moreover, do not install it near a heat source.
W
ARNING
If not enough space is provided, the temperature inside the control rack could rise,
causing temperature error.
Clean the air filter when it is dirty. If the air filter is dirty, insufficient air-flow
might not ensure correct cooling and might stop the marking operation. Clean or
replace the air filter periodically.
Figure 14: Control rack installation environment
W
ARNING
NOTE
The control rack IP rating is IP31 in horizontal position, otherwise IP30.
DO NOT place heavy objects on top of the control rack!
To Next Page
Loading...