Datalogic DM3610 - Tachometer, Trigger, and Transmit Settings

DC3000 USER INTERFACE
59
4
Field Name
Action/Definition
DM3610’s not in this Cluster
To Remove a
Dimensioner from the
System
1. Disconnect a dimensioner’s cables. The Action
column in the disconnected dimensioner’s line displays
a Delete button.
2. Click Delete.
To Replace a
Dimensioner in the
System
1. Connect a dimensioner’s cables to the system. The
dimensioner information is displayed in DM3610's not
in this Cluster.
2. Select Replace in this Cluster from the drop-down of
the dimensioner you want to use to replace the
placeholder shown in DM3610's in this Cluster. The
new dimensioner’s information replaces that of the
placeholder.
To Add a Dimensioner
to the System
1. Connect a dimensioner’s cables to the system. The
dimensioner information is displayed in DM3610's not
in this Cluster.
2. Under Action, select Add to Cluster as New from the
drop-down list of the dimensioner you want to add. The
new dimensioner’s information is added in a new line
under DM3610's in this Cluster.
3. When you have finished making changes, click Update to save or click Reset to
revert to the previously saved values.