Product Reference Guide
13
Chapter 2
Setup
Unpacking
Check carefully to ensure the reader and any accessories ordered are present and undamaged. If
any damage occurred during shipment, contact Datalogic Technical Support. Information is
shown on
page 10
.
KEEP THE PACKAGING. Should the unit ever require s
ervice, it should be returned in its
original shipping container.
Setting Up the Reader
Follow the steps provided in this section to connect and get your reader up and communicating
with its host.
1. Begin by connecting the scan module to the host. The correct Interface Selection will
occur aut
omatically.
2. If modifications are needed, go to
Interface Selection
and set the desired interface.
3.
Configure Interface Settings
(only if not using factory settings for that interface)
4. Go to
Configuring Other Features
(if modifications are needed from factory settings)
To Next Page
Loading...
