Enter/Exit Programming Mode 2D Symbologies
176
Gryphon™ GPS4400
Aztec Code Set Length 1
Specifies one of the bar code lengths for Aztec Code Length Control. Length 1
is the minimum label length if in Variable Length Mode, or the first fixed
length if in Fixed Length
Mode. Characters can be set from 0001 to 3,832
characters in increments of 0001 (pad with zeros).
See page 241 for detailed instructions on setting this feature.
Select Aztec Code Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
bar c
ode again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
CANCEL
DEFAULT
0001 = Length 1 is 1 Character
To Next Page
Loading...
