Enter/Exit Programming Mode 2D Symbologies
186
Gryphon™ GPS4400
Maxicode Set Length 2
This feature specifies one of the bar code lengths for Maxicode Length Control.
Length 2 is the maximum label length if in Variable
Length Mode, or the
second fixed length if in Fixed Length Mode. Characters can be set from
0001 to 0145 characters in increments of 0001 (pad with zeros).
See page 241 for detailed instructions on setting this feature.
Select Maxicode Length 2 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
bar c
ode again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
CANCEL
DEFAULT
Length 2 is 0145 Characters
To Next Page
Loading...
