Enter/Exit Programming Mode 2D Symbologies
192
Gryphon™ GPS4400
Micro PDF417 Set Length 2
This feature specifies one of the bar code lengths for Micro PDF417 Length
Control. Length 2 is the maximum label length if in
Variable Length Mode, or
the second fixed length if in Fixed Length includes the bar code’s data char-
acters only. Characters can be set from 0001 to 03
66 characters (pad with
zeros) in increments of 01. Any value greater than 0366 will be considered
to be 0366.
See page 241 for detailed instructions on setting this feature.
Select Micro PDF417 Length 2 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
bar c
ode again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
CANCEL
DEFAULT
Length 2 is 0366 Characters
To Next Page
Loading...
