Datalogic Gryphon I GPS4400 - Micro QR Code Set Length 2

Enter/Exit Programming Mode 2D Symbologies
198 Gryphon™ GPS4400
Micro QR Code Set Length 2
This feature specifies one of the bar code lengths for Micro QR Code Length
Control. Length 2 is the maximum label length if in Variable Length Mode,
or the second fixed length if in Fixed Length Mode. Characters can be set
from 0001 to 0035 characters in increments of 0001 (pad with zeros).
See page 241 for detailed instructions on setting this feature.
$CMQL2
Select QR Code Length 2 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at le
ft followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing your
desired character(s). End by scan
ning the ENTER/EXIT
bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not sa
ve the entry string. You can then start again
at the beginning.
~
CANCEL
DEFAULT
Length 2 is 0035 Characters