References Symbologies
242
Gryphon™ GPS4400
Follow these instructions to set this feature:
1. Determine the desired character length (from 1 to 50 — or 0 to ignore
this length).
Pad the number with leading zeros to yield two digits. For
example: 0 = 00, 5 = 05, 20 = 20, etc.
2. Go to the Set Length page for your s
elected symbology and scan the
ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
Mode.
3. Scan the bar code to SELECT LENGTH 2
SETT
ING for your selected sym-
bology.
4. Scan the appropriate two digits from the keypad in Appendix D, Key
pad
that represent the length setting which was determined in the
steps
above. You will hear a two-beep indication after the last character.
If you make a mistake, before the last character scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
5. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Program-
ming Mode.
This completes the procedure.
To Next Page
Loading...
