Product Reference Guide
17
RS-232 ONLY INTERFACE
BAUD RATE on page 18
DATA BITS on page 19
STOP BITS on page 19
PARITY on page 20
HANDSHAKING CONTROL on page 21
Use the programming bar codes in this section if modifications to the
standard RS-232
interface settings are necessary to meet your system’s
requirements. Additional settings which apply to both the RS-232 and
USB interfaces are available in the next section, "RS-232/USB-Com Inter-
faces" starting on page
22.
Reference Appendix B, Standard Defaults for a listing of standard factory
settings.
To Next Page
Loading...
