Datalogic Gryphon I GPS4400 User Manual

Technical Specifications
Product Reference Guide 267
Programming Mode : The following indications ONLY occur when the reader is
in Programming Mode
.
Indicator Description LED Beeper
Label Programming
Mode Entry
A valid programming label
has been scanned.
LED blinks continu-
ously
Reader sounds four
low frequency beeps.
Label Programming
Mo
de Rejection of
Label
A label has been rejected.
N/A
Reader sounds three
times at lowest fre-
quency and current
volu
me.
Label Programming
Mode Acceptance of
Partial Label
In cases where multiple
labels
must be scanned to
program one feature, this
indication acknowledges
each portion as it is suc-
cessfully scanned.
N/A
Reader sounds one
short beep at highest
frequency and cur-
rent volume.
Label Programming
Mode Acceptance of
Programm
ing
Configuration option(s)
have been successfully
programmed
via labels and
the reader has exited Pro-
gramming Mode.
N/A
Reader sounds one
high frequency beep
and 4 low frequency
beeps followed by
reset beeps.
Label Programming
Mode C
ancel Item
Entry
Cancel label has been
scanned.
N/A
Reader sounds two
times at low fre-
quency and current
volu
me.
ROM Failure
There is an error in the
reader's softwar
e/pro-
gramming
Flashes
Reader sounds one
error beep at highest
volume.
Limited Scanning
Labe
l Read
Indicates that a host
conn
ection is not estab-
lished.
N/A
Reader 'chirps' six
times at the highest
frequency and current
volume.
Reader Active Mode
The reader is active and
ready to scan.
The LED is lit steadily
a
N/A
Reader
Disabled
The reader has been
disabled by the host.
The LED blinks contin-
uously
N/A
Green Spot
a
flashes
momentarily
Upon successful read of
a labe
l, the software
shall turn the green
spot on for the time
specified by the config-
ured value.
N/A N/A
Image Capture
On when ready to cap-
ture image
LED on N/A
Flash Memory
Update
Occurs while update is
in progress
LED blinks
a
Except when in sleep mode or when a Good Read LED Duration other than 00 is selected
Indicator Description LED Beeper

Datalogic Gryphon I GPS4400 Specifications

General

Type	Fixed bar code reader
Sensor type	Laser
Scanner type	2D
Tilt reading angle	-180 - 180 °
Pitch reading angle	-40 - 40 °
Linear (1D) barcodes supported	-
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, MaxiCode, Micro QR Code, QR Code
Input voltage	5 V
USB version	2.0
Standard interfaces	USB, RS-232
Connectivity technology	Wired
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Buzzer	Yes
Product color	White
Harmonized System (HS) code	84716070

Weight and Dimensions

Depth	73 mm
Width	121 mm
Height	107 mm
Weight	295 g