Datalogic Gryphon I GPS4400 - ACK NAK Timeout Value; ACK NAK Retry Count

Enter/Exit Programming Mode RS-232/USB-Com Interfaces
26 Gryphon™ GPS4400
ACK NAK Timeout Value
This option specifies the amount of time the reader waits for an ACK char-
acter from the host following label transmission. The selectable
timeout
range is 200 milliseconds to 15,000ms (15 seconds) in 200ms increments.
A selection of 0 disables the timeout. See page 236 for more information.
$CR2AT
Select ACK NAK Timeout Value Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left
followed by the digits from the Alphanumeric char-
acters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
ba
r code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
~
CANCEL
DEFAULT
01 ACK NAK Timeout value is 200ms
ACK NAK Retry Count
Specifies the number of times the reader retries a label transmission due to
a retry condition. The selectable range is from 1 to 254 retries. A selection
of 0 disables the count, and a selection of 255 specifies unlimited retries.
See page 237 for more information.
$CR2AR
Select ACK NAK Retry Count Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left
followed by the digits from the Alphanumeric char-
acters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
ba
r code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
~
CANCEL
DEFAULT
003 = 3 Retries