Datalogic Gryphon I GPS4400 - Send Control Characters

Enter/Exit Programming Mode USB Keyboard Settings
34 Gryphon™ GPS4400
Send Control Characters
This feature specifies how the reader transmits ASCII control characters to
the host. Reference Appendix F, Scancode Tables for more information about
control characters.
Options are as follows:
Control Character 00 : Characters from 00 to 0x1F are sent as control character
Ctrl+Keys, special keys are located from 0x80 to 0xA1.
Control Character 01 : Characters from 00 to 0x1F are sent as control character
Ctrl+Shift, special keys are located from 0x80 to 0xA1.
Control Character 02 : Special keys are located from 00 to 0x1F and characters
from 0x80 to 0xFE are intended as an extended ASCII table (see "Microsoft
Windows Codepage 1252" on page 301).
DEFAULT
$CKBSC00(CR)
Reader Send Control Characters = 00
$CKBSC01(CR)
Reader Send Control Characters = 01
$CKBSC02(CR)
Reader Send Control Characters = 02