USB Keyboard Settings Enter/Exit Programming Mode
Product Reference Guide
35
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface.
The selectable range for this feature is from 0 to 99 seconds.
See page 240 in “References” for detailed information and examples for set-
ting this feature.
Set Intercode Delay
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at le
ft followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad
representing your
desired character(s). End by scan
ning the ENTER/EXIT
bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not sa
ve the entry string. You can then start again
at the beginning.
CANCEL
To Next Page
Loading...
