Datalogic Gryphon I GPS4400 - Multiple Label Reading; Multiple Labels Per Frame

Reading Parameters Enter/Exit Programming Mode
Product Reference Guide 77
MULTIPLE LABEL READING
When the reader’s aiming system is activated by a trigger push or other
method (depending on the mode), it then acquires and processes each
image in the area in front of it (the Volume). In this case, the scanner stops
processing the image once it decodes a label. If several labels are present in
the volume, only the first label encountered is decoded and sent.
When Multiple Reading Mode is enabled, the scanner keeps on processing
the image until all the labels present are decoded. The reader then sorts the
data from all the bar codes (if config
ured to do so) before transmitting it.
Multiple Labels per Frame
Specifies the ability of the reader to decode and transmit a set of code labels
in a specific volume and in a single frame of time. When in Multiple Labels
per Frame the reader beeps and turns on the good read LED indication for
each code read in a frame.
When Multiple Labels Mode is enabled, ISBT pairing
, ABC Codabar pairing,
and composites are not allowed.
DEFAULT
$CSNML00(CR)
Multiple Labels per Frame = Disable
$CSNML01(CR)
Multiple Labels per Frame = Enable