Datalogic Gryphon I GPS4400 - Multiple Labels Ordering by Code Length; Multiple Labels Ordering by Code Symbology

Enter/Exit Programming Mode Reading Parameters
78 Gryphon™ GPS4400
Multiple Labels Ordering by Code Symbology
This feature allows you to specify the order multiple labels are transmitted
by symbology type, when Multiple Labels per Frame is enabled. See
page 260 in “References” for detailed information on setting this feature.
$CSNMS
Select Symbologies for Multiple Labels Ordering
To configure, scan the ENTER/EXIT PROGRAMMING
MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters
in
Appendix D, Keypad representing your desired
character(s). End by scanning the E
NTER/EXIT bar
code.
Make a mistake? Scan the CANCEL bar code to abort
and not sa
ve the entry string. You can then start again
at the beginning.
~
CANCEL
DEFAULT
000000000000 = Random order
Multiple Labels Ordering by Code Length
Specifies the transmission ordering by code length, when Multiple Labels
per Frame is enabled.
DEFAULT
$CSNMT00(CR)
Multiple Labels Ordering = Disable
$CSNMT01(CR)
Transmit Increasing Length Order
$CSNMT02(CR)
Transmit Decreasing Length Order