Selecting the Interface Type
Quick Reference Guide 5
To adjust the stand:
1. With fingers, loosen the screw on the bottom of the stand by
turning it counterclockwise.
2. Set the stand upright and slide to adjust to the desired position.
3. Re-tighten the screw to secure the stand.
Selecting the Interface Type
Upon completing the physical connection between the reader and
its host, proceed directly to Interface Selection below for informa-
tion and programming for the interface type the reader is connected
to (RS-232, Keyboard Wedge, USB) and scan the appropriate bar
code to select your system’s correct interface type, according to
your application.
For interfaces other than those listed in this manual, see the Heron
HD3130 Product Reference Guide (PRG), available online at
www.datalogic.com.
To Next Page
Loading...
