Datalogic Heron HD3430 - Configuring the Interface

Selecting the Interface Type
8 Heron™ HD3430
Information and programming options for each interface type are pro-
vided in this section. For defaults and additional information associated
with each interface, proceed to the corresponding chapter in the Heron™
HD3430 PRG.
Configuring the Interface
Scan the appropriate programming bar code to select the interface type
for your system.
NOTE
Unlike some other programming features and options, inter-
face selections require that you scan only one programming
bar code label. DO NOT scan an ENTER/EXIT bar code prior to
scanning an interface selection bar code.
Some interfaces require the scanner to start in the disabled
state when powered up. If additional scanner configuration
is desired while in this state, pull the trigger and hold for 5
seconds. The scanner will change to a state that allows pro-
gramming with bar codes.
RS-232
RS-232 standard interface
Select RS232-STD
RS-232 Wincor-Nixdorf
Select RS232-WN
RS-232 for use with OPOS/UPOS/JavaPOS
Select RS-232 OPOS