Datalogic Heron HD3430 - Reading Parameters; Aiming System; Good Read Green Spot Duration

Reading Parameters
22 Heron™ HD3430
Reading Parameters
Move the reader toward the target and center the aiming pattern and
illumination system to capture and decode the image. See
Using the
Heron HD3430 Imager on page 6
for more information.
The aiming system will briefly switch off after the acquisition time, and if
no code is decoded will switch on again before the next acquisition. The
illuminator will remain on until the symbol is decoded.
As you read code symbols, adjust the distance at which you are holding
the reader.
Aiming System
A number of options for customizing control of the Aiming System are
available. See the Heron HD34XX PRG for more information and program-
ming bar codes.
Good Read Green Spot Duration
Successful reading can be signaled by a good read green spot. Use the bar
codes that follow to specify the duration of the good read pointer beam
after a good read.
GOOD READ GREEN SPOT DURATION
ENTER/EXIT PROGRAMMING MODE
Disabled
 Short (300 ms)
Medium (500 ms)
Long (800 ms)