Datalogic Heron HD3430 - UPC-E Number System Character Transmission

To Next Page

To Previous Page

1D Symbologies Enter/Exit Programming Mode

Product Reference Guide

119

UPC-E Number System Character Transmission

This feature enables/disables transmission of the UPC-E system number char-

acter.

UPC-E Number System Character = Do not transmit

UPC-E Number System Character = Transmit

DEFAULT

$CEBNS00

$CEBNS01

Main Page

Default Chapter3
- Table of Contents3
Introduction9
- About the Scanner9
  - Using the Heron Reader9
- About this Manual10
  - Overview10
  - Manual Conventions11
- Technical Support11
Setup13
- Unpacking13
- Setting up the Scanner13
- Using the Heron HD3430 Imager19
- Interface Selection21
  - Configuring the Interface21
- Customizing Configuration Settings24
Configuration Using Bar Codes27
- Configuration Parameters27
- Global Interface Features29
  - Host Commands - Obey/Ignore29
  - USB Suspend Mode30
- Only Interface31
- RS-232 Standard Factory Settings31
- Baud Rate31
- Data Bits32
- Stop Bits33
- Parity33
  - Rs-232 Only Interface33
- Handshaking Control35
- Rs-232/Usb-Com Interfaces37
- Standard Factory Settings37
- Intercharacter Delay37
- Beep on ASCII BEL37
- Beep on Not on File39
- ACK NAK Options40
  - ACK Character41
  - NAK Character41
  - ACK NAK Timeout Value42
  - ACK NAK Retry Count43
  - ACK NAK Error Handling44
- Indicate Transmission Failure45
- Disable Character45
- Enable Character46
- Keyboard Interface47
- Country Mode48
  - Setup on PC to Use ALT Universal48
  - Setting Country Mode49
  - Setting Encoding Type63
  - Setting ALT Output Type70
Caps Lock State71
Numlock71
Keyboard Numeric Keypad72
Keyboard Send Control Characters73
Wedge Quiet Interval74
Intercharacter Delay75
Intercode Delay76
USB Keyboard Speed77
Usb-Oem Interface79
Introduction79
Standard Factory Settings79
USB-OEM Device Usage80
USB-OEM Interface Options80
Data Format81
Global Prefix/Suffix82
- Global Prefix /Suffix82
Global AIM ID83
Gs1-128 Aim ID83
Label ID84
- Label ID: Pre-Loaded Sets84
- Label ID: Set Individually Per Symbology85
- Label ID Control85
- Label ID Symbology Selection86
Case Conversion92
Character Conversion92
Reading Parameters93
Double Read Timeout94
LED and Speaker Indicators96
- Power on Alert96
Audio Jingles96
- Audio Jingle Enable98
- Select Audio Jingle for Power-Up Event99
- Select Audio Jingle for Good Read Event100
- Select Audio Jingle for Enter Stand Mode101
- Select Audio Jingle for Exit Stand Mode102
- Select Audio Jingle for Transmit Error Sound103
- Good Read: When to Indicate104
- Good Read Beep Type105
- Good Read Beep Frequency105
- Good Read Speaker Volume106
- Good Read Beep Length107
RGB LED Settings109
- Enable/Disable Good Read Indicator110
- Good Read LED Color110
- Enable/Disable Body Illumination111
- Scanner Idle LED Color112
- RGB Good Read Raising Time113
- RGB Good Read Falling Time114
- RGB Good Read Holding Time115
- RGB Auto Delay116
Scanning Features117
- Scan Mode117
- Scanning Active Time118
- Stand Mode Flash118
- Flash on Time119
- Flash off Time119
- Stand Mode Sensitivity120
- Pick Mode121
- Introduction123
- Standard Factory Settings for Symbologies123
1D Symbologies123
- Disable All Symbologies124
- Coupon Control124
- Upc-A125
- Upc-E127
- Ean 13130
- Ean 8133
- UPC/EAN Global Settings135
  - UPC/EAN Price Weight Check135
- Add-Ons136
  - Optional Add-Ons136
  - Optional Add-On Timer137
- GS1 Databar ™ Omnidirectional138
  - GS1 Databar Omnidirectional Enable/Disable138
  - GS1 Databar Omnidirectional GS1-128 Emulation138
- GS1 Databar™ Expanded139
- GS1 Databar™ Limited142
  - GS1 Databar Limited Enable/Disable142
  - GS1 Databar Limited GS1-128 Emulation142
- Code 39143
- Code 32 (Italian Pharmaceutical)151
- Code 39 CIP (French Pharmaceutical)152
  - Code 39 CIP Enable/Disable152
- Code 128153
Gs1-128159
- GS1-128 Enable159
Interleaved 2 of 5 (I 2 of 5)160
- I 2 of 5 Enable/Disable160
- I 2 of 5 Check Character Calculation161
- I 2 of 5 Check Character Transmission162
- I 2 of 5 Length Control163
- I 2 of 5 Set Length 1164
- I 2 of 5 Set Length 2165
Interleaved 2 of 5 CIP HR166
- Interleaved 2 of 5 CIP HR Enable/Disable166
Datalogic 2 of 5167
- Datalogic 2 of 5 Enable/Disable167
- Datalogic 2 of 5 Check Character Calculation167
- Datalogic 2 of 5 Check Character Transmission168
- Datalogic 2 of 5 Length Control168
- Datalogic 2 of 5 Set Length 1169
- Datalogic 2 of 5 Set Length 2170
Codabar171
- Codabar Enable/Disable171
- Codabar Check Character Calculation171
- Codabar Check Character Transmission172
- Codabar Start/Stop Character Transmission172
- Codabar Start/Stop Character Set173
- Codabar Start/Stop Character Match173
- Codabar Quiet Zones174
- Codabar Length Control175
- Codabar Set Length 1176
- Codabar Set Length 2177
ABC Codabar178
- ABC Codabar Enable/Disable178
- ABC Codabar Concatenation Mode178
- ABC Codabar Dynamic Concatenation Timeout179
- ABC Codabar Force Concatenation179
Code 11180
- Code 11 Enable/Disable180
- Code 11 Check Character Calculation181
- Code 11 Check Character Transmission181
- Code 11 Length Control182
- Code 11 Set Length 1182
- Code 11 Set Length 2183
Standard 2 of 5184
- Standard 2 of 5 Enable/Disable184
- Standard 2 of 5 Check Character Calculation184
- Standard 2 of 5 Check Character Transmission185
- Standard 2 of 5 Length Control185
- Standard 2 of 5 Set Length 1186
- Standard 2 of 5 Set Length 2187
Industrial 2 of 5188
- Industrial 2 of 5 Enable/Disable188
- Industrial 2 of 5 Check Character Calculation188
- Industrial 2 of 5 Check Character Transmission189
- Industrial 2 of 5 Length Control189
- Industrial 2 of 5 Set Length 1190
- Industrial 2 of 5 Set Length 2191
- Iata192
  - IATA Enable/Disable192
  - IATA Check Character Transmission192
- Isbt 128193
  - ISBT 128 Concatenation193
  - ISBT 128 Concatenation Mode193
  - ISBT 128 Dynamic Concatenation Timeout194
  - ISBT 128 Force Concatenation195
  - ISBT 128 Advanced Concatenation Options195
- Msi196
  - MSI Enable/Disable196
  - MSI Check Character Calculation196
  - MSI Check Character Transmission197
  - MSI Length Control197
  - MSI Set Length 1198
  - MSI Set Length 2199
- Code 93200
  - Code 93 Enable/Disable200
  - Code 93 Check Character Calculation201
  - Code 93 Check Character Transmission201
  - Code 93 Length Control202
  - Code 93 Set Length 1203
  - Code 93 Set Length 2204
  - Code 93 Quiet Zones205
- Follett 2 of 5206
  - Follett 2 of 5 Enable/Disable206
- Bc412206
  - BC412 Enable/Disable206
  - BC412 Check Character Calculation207
  - BC412 Length Control207
  - BC412 Set Length 1208
  - BC412 Set Length 2209
- 2D Symbologies211
- 2 D Global Features212
  - Maximum Decoding Time212
  - Structured Append213
  - 2D Normal/Inverse Symbol Control213
- Symbology Selection214
- Aztec Code214
  - Aztec Code Enable / Disable214
  - Aztec Code Length Control214
- China Sensible Code217
  - China Sensible Code Enable / Disable217
  - China Sensible Code Length Control217
- Data Matrix220
  - Data Matrix Enable / Disable220
  - Data Matrix Square/Rectangular Style220
  - Data Matrix Length Control221
- Maxicode223
  - Maxicode Enable / Disable223
  - Maxicode Primary Message Transmission223
  - Maxicode Length Control224
- Pdf417226
  - PDF417 Enable / Disable226
  - PDF417 Length Control226
- Micro PDF417229
  - Micro PDF417 Enable / Disable229
  - Micro PDF417 Code 128 GS1-128 Emulation229
  - Micro PDF417 Length Control230
- QR Code232
  - QR Code Enable / Disable232
  - QR Code Length Control232
- Micro QR Code235
  - Micro QR Code Enable/Disable235
  - Micro QR Code Length Control235
- UCC Composite238
  - UCC Composite Enable / Disable238
  - UCC Optional Composite Timer239
- Postal Code Selection240
  - Postnet BB Control241
References243
- Parameters244
  - Only244
  - RS-232/USB COM Parameters245
- Keyboard Interface252
- Data Format255
- Reading Parameters263
  - RGB LED Features263
- Scanning Features266
- Symbologies270
  - Set Length272
Technical Specifications273
- LED and Beeper Indications276
  - Programming Mode277
- Troubleshooting278
- Standard Cable Pinouts279
- Stand Dimensions280
- Stand Base Plate Template281
Standard Defaults283
- Default Exceptions291
Sample Bar Codes295
Keypad299
Scancode Tables301
- Control Character Emulation301
  - Single Press and Release Keys301
- Interface Type PC at PS/2 or USB-Keyboard302
- Interface Type PC at PS/2 Alt Mode or USB-Keyboard Alt Mode304
- Microsoft Windows Codepage 1252306
Index307

Datalogic Heron HD3430 - UPC-E Number System Character Transmission

Table of Contents

Other manuals for Datalogic Heron HD3430

Related product manuals