1D Symbologies Enter/Exit Programming Mode
Product Reference Guide
131
GS1 DataBar Expanded Set Length 2
This feature specifies one of the bar code lengths for GS1 DataBar Expanded
Length Control on page 130. Length 2 is the maximum label length if in Vari-
able Length on page 130 Mode, or the second fixed length if in Fixed Length on
page 130 Mode. Length includes the bar code’s data char
acters only.
The length can be set from 1 to 74 characters. A setting of 00 specifies to
ignore this length (only one fixed length). See "Set Length 2" on
page 262 for
more detailed progr
amming instructions.
Select GS1 DataBar Expanded Set Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
74 = Length 2 is 74 Characters
$CXBL2
~
To Next Page
Loading...
