Enter/Exit Programming Mode Datalogic 2 of 5
160 Heron™ HD3430
Datalogic 2 of 5 Set Length 2
This feature specifies one of the bar code lengths for Datalogic 2 of 5 Length
Control on page 158. Length 2 is the maximum label length if in Variable
Length on page 153 Mode, or the second fixed l
ength if in Fixed Length on
page 153 Mode. The length includes the bar
code’s data characters only.
The length can be set from 2 to 50 characters. A setting of 00 specifies to
ignore this length (only one fixed length). See "Set Length 2" on
page 262 for
more detailed programming instructions.
Select Datalogic 2 of 5 Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
50 = Length 2 is 50 Characters
$CD2L2
~
To Next Page
Loading...
