Datalogic Heron HD3430 - Case Conversion; Character Conversion

Enter/Exit Programming Mode Case Conversion
84 Heron™ HD3430
Case Conversion
This feature allows conversion of the case of all alphabetic characters to upper
or lower case.
NOTE
DEFAULT
Case Conversion = Disable (no case conversion)
Case Conversion = Convert to upper case
Case Conversion = Convert to lower case
Case conversion affects ONLY scanned bar code data, and does not affect
Label ID, Prefix, Suffix, or other appended data.
Character Conversion
Character conversion is an eight byte configuration item. The eight bytes are 4
character pairs represented in hexadecimal ASCII values. The first character in
the pair is the character that will be converted. The second character in the pair
is the character to convert to. If the character to convert in a pair is FF, then no
conversion is done. See "Character Conversion" on
page 252 for more detailed
programming instructions.
Configure Character Conversion
DEFAULT
0xFFFFFFFFFFFFFFFF 
(No character conversion)
$CLFCA00
$CLFCA01
$CLFCA02
$CLFCH