Datalogic Heron HD3430

To Next Page

To Previous Page

Reading Parameters Enter/Exit Programming Mode

Product Reference Guide

You will be prompted to specify a sound file to upload. The supported format of

audio files is WAV uncompressed PCM. Best quality is obtained using stereo

audio files with 16 bit encoding.

Up to 15 jingles can be uploaded and programmed.

Main Page

Default Chapter3
- Table of Contents3
Introduction9
- About the Scanner9
  - Using the Heron Reader9
- About this Manual10
  - Overview10
  - Manual Conventions11
- Technical Support11
Setup13
- Unpacking13
- Setting up the Scanner13
- Using the Heron HD3430 Imager19
- Interface Selection21
  - Configuring the Interface21
- Customizing Configuration Settings24
Configuration Using Bar Codes27
- Configuration Parameters27
- Global Interface Features29
  - Host Commands - Obey/Ignore29
  - USB Suspend Mode30
- Only Interface31
- RS-232 Standard Factory Settings31
- Baud Rate31
- Data Bits32
- Stop Bits33
- Parity33
  - Rs-232 Only Interface33
- Handshaking Control35
- Rs-232/Usb-Com Interfaces37
- Standard Factory Settings37
- Intercharacter Delay37
- Beep on ASCII BEL37
- Beep on Not on File39
- ACK NAK Options40
  - ACK Character41
  - NAK Character41
  - ACK NAK Timeout Value42
  - ACK NAK Retry Count43
  - ACK NAK Error Handling44
- Indicate Transmission Failure45
- Disable Character45
- Enable Character46
- Keyboard Interface47
- Country Mode48
  - Setup on PC to Use ALT Universal48
  - Setting Country Mode49
  - Setting Encoding Type63
  - Setting ALT Output Type70
Caps Lock State71
Numlock71
Keyboard Numeric Keypad72
Keyboard Send Control Characters73
Wedge Quiet Interval74
Intercharacter Delay75
Intercode Delay76
USB Keyboard Speed77
Usb-Oem Interface79
Introduction79
Standard Factory Settings79
USB-OEM Device Usage80
USB-OEM Interface Options80
Data Format81
Global Prefix/Suffix82
- Global Prefix /Suffix82
Global AIM ID83
Gs1-128 Aim ID83
Label ID84
- Label ID: Pre-Loaded Sets84
- Label ID: Set Individually Per Symbology85
- Label ID Control85
- Label ID Symbology Selection86
Case Conversion92
Character Conversion92
Reading Parameters93
Double Read Timeout94
LED and Speaker Indicators96
- Power on Alert96
Audio Jingles96
- Audio Jingle Enable98
- Select Audio Jingle for Power-Up Event99
- Select Audio Jingle for Good Read Event100
- Select Audio Jingle for Enter Stand Mode101
- Select Audio Jingle for Exit Stand Mode102
- Select Audio Jingle for Transmit Error Sound103
- Good Read: When to Indicate104
- Good Read Beep Type105
- Good Read Beep Frequency105
- Good Read Speaker Volume106
- Good Read Beep Length107
RGB LED Settings109
- Enable/Disable Good Read Indicator110
- Good Read LED Color110
- Enable/Disable Body Illumination111
- Scanner Idle LED Color112
- RGB Good Read Raising Time113
- RGB Good Read Falling Time114
- RGB Good Read Holding Time115
- RGB Auto Delay116
Scanning Features117
- Scan Mode117
- Scanning Active Time118
- Stand Mode Flash118
- Flash on Time119
- Flash off Time119
- Stand Mode Sensitivity120
- Pick Mode121
- Introduction123
- Standard Factory Settings for Symbologies123
1D Symbologies123
- Disable All Symbologies124
- Coupon Control124
- Upc-A125
- Upc-E127
- Ean 13130
- Ean 8133
- UPC/EAN Global Settings135
  - UPC/EAN Price Weight Check135
- Add-Ons136
  - Optional Add-Ons136
  - Optional Add-On Timer137
- GS1 Databar ™ Omnidirectional138
  - GS1 Databar Omnidirectional Enable/Disable138
  - GS1 Databar Omnidirectional GS1-128 Emulation138
- GS1 Databar™ Expanded139
- GS1 Databar™ Limited142
  - GS1 Databar Limited Enable/Disable142
  - GS1 Databar Limited GS1-128 Emulation142
- Code 39143
- Code 32 (Italian Pharmaceutical)151
- Code 39 CIP (French Pharmaceutical)152
  - Code 39 CIP Enable/Disable152
- Code 128153
Gs1-128159
- GS1-128 Enable159
Interleaved 2 of 5 (I 2 of 5)160
- I 2 of 5 Enable/Disable160
- I 2 of 5 Check Character Calculation161
- I 2 of 5 Check Character Transmission162
- I 2 of 5 Length Control163
- I 2 of 5 Set Length 1164
- I 2 of 5 Set Length 2165
Interleaved 2 of 5 CIP HR166
- Interleaved 2 of 5 CIP HR Enable/Disable166
Datalogic 2 of 5167
- Datalogic 2 of 5 Enable/Disable167
- Datalogic 2 of 5 Check Character Calculation167
- Datalogic 2 of 5 Check Character Transmission168
- Datalogic 2 of 5 Length Control168
- Datalogic 2 of 5 Set Length 1169
- Datalogic 2 of 5 Set Length 2170
Codabar171
- Codabar Enable/Disable171
- Codabar Check Character Calculation171
- Codabar Check Character Transmission172
- Codabar Start/Stop Character Transmission172
- Codabar Start/Stop Character Set173
- Codabar Start/Stop Character Match173
- Codabar Quiet Zones174
- Codabar Length Control175
- Codabar Set Length 1176
- Codabar Set Length 2177
ABC Codabar178
- ABC Codabar Enable/Disable178
- ABC Codabar Concatenation Mode178
- ABC Codabar Dynamic Concatenation Timeout179
- ABC Codabar Force Concatenation179
Code 11180
- Code 11 Enable/Disable180
- Code 11 Check Character Calculation181
- Code 11 Check Character Transmission181
- Code 11 Length Control182
- Code 11 Set Length 1182
- Code 11 Set Length 2183
Standard 2 of 5184
- Standard 2 of 5 Enable/Disable184
- Standard 2 of 5 Check Character Calculation184
- Standard 2 of 5 Check Character Transmission185
- Standard 2 of 5 Length Control185
- Standard 2 of 5 Set Length 1186
- Standard 2 of 5 Set Length 2187
Industrial 2 of 5188
- Industrial 2 of 5 Enable/Disable188
- Industrial 2 of 5 Check Character Calculation188
- Industrial 2 of 5 Check Character Transmission189
- Industrial 2 of 5 Length Control189
- Industrial 2 of 5 Set Length 1190
- Industrial 2 of 5 Set Length 2191
- Iata192
  - IATA Enable/Disable192
  - IATA Check Character Transmission192
- Isbt 128193
  - ISBT 128 Concatenation193
  - ISBT 128 Concatenation Mode193
  - ISBT 128 Dynamic Concatenation Timeout194
  - ISBT 128 Force Concatenation195
  - ISBT 128 Advanced Concatenation Options195
- Msi196
  - MSI Enable/Disable196
  - MSI Check Character Calculation196
  - MSI Check Character Transmission197
  - MSI Length Control197
  - MSI Set Length 1198
  - MSI Set Length 2199
- Code 93200
  - Code 93 Enable/Disable200
  - Code 93 Check Character Calculation201
  - Code 93 Check Character Transmission201
  - Code 93 Length Control202
  - Code 93 Set Length 1203
  - Code 93 Set Length 2204
  - Code 93 Quiet Zones205
- Follett 2 of 5206
  - Follett 2 of 5 Enable/Disable206
- Bc412206
  - BC412 Enable/Disable206
  - BC412 Check Character Calculation207
  - BC412 Length Control207
  - BC412 Set Length 1208
  - BC412 Set Length 2209
- 2D Symbologies211
- 2 D Global Features212
  - Maximum Decoding Time212
  - Structured Append213
  - 2D Normal/Inverse Symbol Control213
- Symbology Selection214
- Aztec Code214
  - Aztec Code Enable / Disable214
  - Aztec Code Length Control214
- China Sensible Code217
  - China Sensible Code Enable / Disable217
  - China Sensible Code Length Control217
- Data Matrix220
  - Data Matrix Enable / Disable220
  - Data Matrix Square/Rectangular Style220
  - Data Matrix Length Control221
- Maxicode223
  - Maxicode Enable / Disable223
  - Maxicode Primary Message Transmission223
  - Maxicode Length Control224
- Pdf417226
  - PDF417 Enable / Disable226
  - PDF417 Length Control226
- Micro PDF417229
  - Micro PDF417 Enable / Disable229
  - Micro PDF417 Code 128 GS1-128 Emulation229
  - Micro PDF417 Length Control230
- QR Code232
  - QR Code Enable / Disable232
  - QR Code Length Control232
- Micro QR Code235
  - Micro QR Code Enable/Disable235
  - Micro QR Code Length Control235
- UCC Composite238
  - UCC Composite Enable / Disable238
  - UCC Optional Composite Timer239
- Postal Code Selection240
  - Postnet BB Control241
References243
- Parameters244
  - Only244
  - RS-232/USB COM Parameters245
- Keyboard Interface252
- Data Format255
- Reading Parameters263
  - RGB LED Features263
- Scanning Features266
- Symbologies270
  - Set Length272
Technical Specifications273
- LED and Beeper Indications276
  - Programming Mode277
- Troubleshooting278
- Standard Cable Pinouts279
- Stand Dimensions280
- Stand Base Plate Template281
Standard Defaults283
- Default Exceptions291
Sample Bar Codes295
Keypad299
Scancode Tables301
- Control Character Emulation301
  - Single Press and Release Keys301
- Interface Type PC at PS/2 or USB-Keyboard302
- Interface Type PC at PS/2 Alt Mode or USB-Keyboard Alt Mode304
- Microsoft Windows Codepage 1252306
Index307

Datalogic Heron HD3430 - Page 97

Table of Contents

Other manuals for Datalogic Heron HD3430

Related product manuals