DIAGNOSTICS
96
SAFERY LASER SCANNER
Display Menu
To enter the Display Menu, push the squared button. By using the up and down arrows
button, it is possible to browse the menu. To select an area, press the squared button.
To exit every menu option, push the squared button after selecting it.
The menu is divided into three main areas: Information, Settings and Exit:
Hardware
Device Name
Model Code
Part Number
Serial Number
Firmware Version
Device Lifetime (h): sho
ws the device lifetime in hours
Configuration
Configuration Name
Safety Signature
Last Conf. Date: sho
ws the date of the last configuration
Main IP Address
MAC Address
Display Settings
Rotate: rotates the screen depending on the device position
Reset SLS
Restores normal operation after a failure lockout condition
(for more information, see "Reset" on page 85)
Diagnostics Using the Display
The display supplies information about the status of the safety laser scanner, and for
diagnostics and troubleshooting.
NOTE
INFORMATION
SETTINGS
EXIT
The refresh rate of the display is slower than the switching rate of the
OSSD output. Therefore, it may occur that the display may not be synchro-
nized with the OSSD output in the case of rapidly switching states.
To Next Page
Loading...
