SCANNER MOUNTING AND PITCH ANGLE ADJUSTMENT
INSTRUCTION MANUAL
33
Figure 7 - Scanner Mounting and Pitch Angle Adjustment
To place a device with a specific pitch angle:
• Screw without tightening the M5 Scanner Fastening Screws (7),
the M5 Pitch
Adjusting Screws (6) and the Positioning Memory Bracket (8) with the M4 screw
(9).
• Rotate the device to reach the desired pitch angle within the allowed range (+/-
6°).
• Tighten the M5 Scanner Fastening Screws (7) and
then the M5 Pitch Adjusting
Screws (6) (2.9 - 3.1 Nm Torque).
• In the end, tighten the Positioning Memory Bracket M4 screw (9)
(1.5 – 1.6 Nm
Torque).
To Next Page
Loading...
