Datalogic Magellan 1500i - Software Flow Control

ENTER/EXIT PROGRAMMING MODE
96 MAGELLAN™ 1500I
RS-232 Software Flow Control
Enables/disables RS‐232 Flow Control using XON/ XOFF characters.
NOTE
This item will be ignored when the feature, R
S-232 NAK Character, is
enabled
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
002100(CR)
RS-232 Software Flow Control= Disable
002101(CR)
RS-232 Software Flow Control= Enable
DEFAULT