Datalogic Magellan 1500i - ACK NAK Features; ACK NAK Enable

ENTER/EXIT PROGRAMMING MODE
98 MAGELLAN™ 1500I
RS-232 ACK NAK Features
ACK NAK Enable
This enables/disables the ability of the scanner to support the RS‐232 ACK/NAK protocol.
When configured, the scanner and/or host sends an “ACK” when it receives data properly,
and sends “NAK” when the data is in error. Selections for this option are:
•Disable ACK NAK
• Enable for Label Transmission — the scanner expects an ACK/NAK response from the
hos
t when a label is sent)
• Enable for Host Acknowledgement — Enabled for Host Commands (the scanner will
r
espond with ACK/NAK when the host sends a command)
• Enable for Label & Host — Enabled for both Label Transmission & Host Command
acknowledg
ement.
To select the option for RS‐232 ACK NAK Enable:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the desired option from barcodes below and on the following page. You’ll need
t
o cover any unused barcodes on this and the facing page to ensure that the scanner
reads only the barcode you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
061100(CR)
RS-232 ACK NAK = Disable
061101(CR)
RS-232 ACK NAK = Enable for Label Transmission
061102(CR)
RS-232 ACK NAK = Enable for Host Acknowledgement
061103(CR)
RS-232 ACK NAK = Enable for Label & Host
DEFAULT