Datalogic Magellan 1500i - UPC-A Number System Character Transmission

ENTER/EXIT PROGRAMMING MODE
130 MAGELLAN™ 1500I
UPC-A Number System Character Transmission
Enables/disables transmission of a UPC‐A number system character.
NOTE
This item is ignored when the advanced feature, Full Label Edit,
is enabled.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
00D300(CR)
UPC-A Number System Character Transmission =
Disable
00D301(CR)
UPC-A Number System Character Transmission =
Enable
DEFAULT