Datalogic Magellan 1500i - UPC-A Check Character Transmission

UPC-A ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 131
UPC-A Check Character Transmission
Enables/disables transmission of a UPC‐A check character.
NOTE
This item is ignored when the advanced feature, Full Label Edit,
is enabled.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
00B700(CR)
UPC-A Check Character Transmission = Disable
00B701(CR)
UPC-A Check Character Transmission = Enable
DEFAULT