Datalogic Magellan 1500i - Upc-E; UPC-E Enable

ENTER/EXIT PROGRAMMING MODE
134 MAGELLAN™ 1500I
UPC-E
UPC-E Enable
Enables/disables the ability of the scanner to decode UPC‐E labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
02D100(CR)
UPC-E = Disable
02D101(CR)
UPC-E = Enable
DEFAULT