Datalogic Magellan 1500i - Installing the Tilting Stand; Riser; EAS Cable; Installing the Stand

OPTIONAL STAND/RISER/MOUNT
6 MAGELLAN™ 1500I
Installing the Tilting Stand / Riser
Follow the instructions below to install or remove the Tilting Stand and the Riser.
EAS Cable
Before installing the Stand or Riser, ensure that the EAS cable for your unit (see Figure 3 on
page 4) is secured.
• If the EAS will be used, be sure the EAS cable is placed into the notch in the enclosure
as shown
below.
After the stand is installed, the wire can be pulled to extend the wire
for accessibility if needed.
• If the EAS cable is not needed, the EAS cable can be tucked inside the product next to
the host Interface connector.
Installing the Stand
1. To install the bottom cover on the unit, insert the tabs into the bottom of the scanner
at the front edge. If you need access to the EAS cable, feed it through the hole in the
bottom cover.
2. Push
up on the back of the bottom cover to snap in place.
1
2
Bottom
Cover
Notch
EAS Cable