EAN-8 ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
151
EAN-8/Jan-8 Both Guards Substitution
Enables/disables the ability of the scanner to find an EAN/JAN8 guard pattern in cases
where the EAN/JAN8 margin makes the guard look like a character.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
DEFAULT
EAN-8/JAN-8 Both Guards Substitution = Disable
EAN-8/JAN-8 Both Guards Substitution = Enable
To Next Page
Loading...
