OTHER UPC/EAN OPTIONS ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
167
Enable EAN Two Label
Enables/disables the ability of the scanner to decode EAN two‐label pairs.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
NOTE
EAN Two Label = Disable
EAN Two Label = Enable
Contact Customer Support for details about advanced program-
ming for this feature.
DEFAULT
To Next Page
Loading...
