Datalogic Magellan 1500i - UPC;EAN Composites

OTHER UPC/EAN OPTIONS ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 177
UPC/EAN Composites
Enables/Disables Composites for the UPC/EAN families of labels.
The value is a bit field where the bits mean the following:
• A setting of 0 (zero) disables this feature.
•Bit0 ‐ if
set enabled Composites for UPCE, If clear disables Composites for UPCE
•Bit1 ‐ if
set enabled Composites for UPCA, If clear disables Composites for UPCA
•Bit2 ‐ if
set enabled Composites for EAN8, If clear disables Composites for EAN8
•Bit3 ‐ if
set enabled Composites for EAN13, If clear disables Composites for EAN13:
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode below. You’ll need to cover any unused barcodes on this and the fac‐
ing page to ensure that the scanner reads only the barcode you intend to scan.
3. Scan the appropriate digits from the
Alpha-Numeric Keypad on page 305 that repre‐
sent the desired number. The selectable range is 0‐15 r
esets. Pad all single and double
digit numbers with leading zeroes to yield a two‐digit entry (00‐15).
4. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
02FE(CR)
SetUPC/EAN Composites
Default setting for this feature is:
00 - Disabled
DEFAULT