Datalogic Magellan 1500i - GS1 Databar; Databar Omnidirectional; Databar Omnidirectional Enable

GS1 DATABAR ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 179
GS1 DATABAR
The symbology family GS1 DataBar™ was formerly known as Reduced Space Symbology
(RSS). For the purpose of simplicity, GS1 DataBar variants are listed in this manual as
“DataBar.”
DATABAR OMNIDIRECTIONAL
DataBar Omnidirectional Enable
Enables/disables the ability of the scanner to decode DataBar Omnidirectional labels.
NOTE
This value-added feature is a factory-programmed option. Con-
tact your dealer for information about upgrading your system to
include this advanced capability.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
04D000(CR)
DataBar Omnidirectional = Disable
04D001(CR)
DataBar Omnidirectional = Enable
DEFAULT