Datalogic Magellan 1500i - Databar Omnidirectional Minimum Read

ENTER/EXIT PROGRAMMING MODE
182 MAGELLAN™ 1500I
DataBar Omnidirectional Minimum Read
This feature specifies the minimum number of consecutive DataBar Omnidirectional
decodes before is accepted as good read.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
04D201(CR)
DataBar Omnidirectional Minimum Read = 1
04D202(CR)
DataBar Omnidirectional Minimum Read = 2
04D203(CR)
DataBar Omnidirectional Minimum Read = 3
04D204(CR)
DataBar Omnidirectional Minimum Read = 4
DEFAULT