Datalogic Magellan 1500i - Databar Omnidirectional Double Read Timeout

DATABAR OMNIDIRECTIONAL ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 183
DataBar Omnidirectional Double Read Timeout
Specifies the minimum allowable time which must pass before reading the same DataBar Omnidi‐
rectional label again (e.g. two identical items in succession).
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
Complete the programming sequence by scanning the Enter/Exit Programming Mode bar‐
code.
00510A(CR)
DataBar Omnidirectional Double Read
Timeout = 0.5 Seconds
005114(CR)
DataBar Omnidirectional Double Read
Timeout = 1 Second
DEFAULT
005132(CR)
DataBar Omnidirectional Double Read
Timeout = 2.5 Seconds
00513C(CR)
DataBar Omnidirectional Double Read
Timeout = 3 Seconds
005146(CR)
DataBar Omnidirectional Double Read
Timeout = 3.5 Seconds