Datalogic Magellan 1500i - Databar Limited; Databar Limited Enable

ENTER/EXIT PROGRAMMING MODE
184 MAGELLAN™ 1500I
DATABAR LIMITED
DataBar Limited Enable
Enables/disables the ability of the scanner to decode DataBar Limited labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
DEFAULT
035400(CR)
Databar Limited = Disable
035401(CR)
Databar Limited = Enable