Datalogic Magellan 1500i - Databar Limited Minimum Read

DATABAR LIMITED ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 185
DataBar Limited Minimum Read
This feature specifies the minimum number of consecutive Databar Limited decodes before
is accepted as good read.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
DEFAULT
035501(CR)
Databar Limited Minimum Read = 1
035502(CR)
Databar Limited Minimum Read = 2
035503(CR)
Databar Limited Minimum Read = 3
035504(CR)
Databar Limited Minimum Read = 4