OPTIONAL STAND/RISER/MOUNT
10
MAGELLAN™ 1500I
3. After removing the Interface Cable and the EAS cable pull the bottom of the Stand /
Riser directly forward (towards the Front Window) to detach it from the unit. Do not
twist or pull sideways. It will snap free if oriented correctly.
L-Bracket / Wall Mount Installation
1. Install the bottom cover on the unit by inserting tabs into the bottom of the scanner
at the front edge and snapping in place at the back. Ensure the EAS cable is not
pinched by the bottom cover, see
EAS Cable on page 6.
2. Affix the L Bracket to the desired surface using provided screws or similar. The head of
the screw must not protrude above the main face of the bracket. Do NOT use flathead
screws for installation.
To Next Page
Loading...
