Datalogic Magellan 1500i - Databar Expanded 2 D Component Enable

ENTER/EXIT PROGRAMMING MODE
190 MAGELLAN™ 1500I
DataBar Expanded 2D Component Enable
When this feature is enabled, the software will not decode an DataBar Expanded barcode
with a 2D component associated with it, and the 2D component will be discarded.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
04D700(CR)
DataBar Expanded 2D Component = Disable
04D701(CR)
DataBar Expanded 2D Component = Enable
DEFAULT